Description
NMEA 2000 starter kit
Contents
- 1 x Power cable
- 1 x 2' cable
- 1 x 15' cable
- 2 x T-connectors
- 2 x Network terminators
Fuel Data Manager
- Replaces EP-85
- Monitors Fuel Rate/Fuel Flow from NMEA 2000 engines, and accumulates Fuel Rate into Fuel Used
- Outputs: Seasonal/Trip/Total Fuel Used
- Will report accurate Vessel Fuel Remaining if MFD Fuel screen is maintained at
every refuel
- One sensor will monitor up to 3 engines
- Additional Fuel Data Managers can be added for more engines
- Will monitor fuel rates from multiple engines transmitting through a single gateway
Fuel flow sensor, with 10 ft cable and T-connector
Fuel Flow Sensor Gasoline only. One required per engine. Up to 3 engines supported. Outputs:
- Fuel Flow
- Tank Fuel Used
- Trip Fuel Used
- Seasonal Fuel Used
|
Cable Length |
10 Ft |
|
Fuel Line Diameter |
3/8" (9. 5 mm) Inside Diameter |
|
Flow Rate Measured |
Optimized for 0. 6-45 Gal/hr but can measure outside these values |
|
Added Back Pressure to the fuel system |
0. 5 PSI at 20 Gal/hr; 1 PSI at 40 Gal/hr |
|
Installation Location |
Above the max level of the fuel tank, in-line after the fuel filter and any Y's or T's in the line |
|
Package |
The Fuel Flow Sensor, N2K T and 2 (two) 1" hose clamps |
|
Fuel Type |
Gasoline only. The Fuel Flow Sensor does not operate diesel engine fuel systems. |
|
Hole required to route through a bulkhead |
22mm (7/8") |
|
Multiple Fuel Flow sensors possible |
Yes |
